PANDUIT: Electrical Full Line

For technical assistance in the U.S., call 866-405-6654 (outside the U.S., see inside back cover for directory) ELECTRICAL SOLUTIONS C1.49 B2. Cable Accessories C1. Wiring Duct C3. Abrasion Protection C4. Cable Management D1. Terminals D2. Power Connectors E1. Labeling Systems E2. Labels E3. Pre-Printed & Write-On Markers F. Index B3. Stainless Steel Ties C2. Surface Raceway E5. Lockout/ Tagout & Safety Solutions B1. Cable Ties A. System Overview D3. Grounding Connectors E4. Permanent Identification Installation Tips: Application of Latex Paint on Panduct ® Wiring Duct Cutting Wiring Duct and Cover Recommended Precaution when Using Type NNC and NE Wiring Duct The following is recommended to properly prepare the surface of the wiring duct/raceway and covers for the best adhesion of latex paint: 1. Clean surface with mild soap and water solution or mineral spirits with a clean lint free towel. Allow to dry. 2. Using a sanding pad (such as synthetic stripping pad or medium/fine steel wool), slightly roughen the surface to be painted. 3. Apply a coat of all-purpose 100% acrylic primer and allow to dry. 4. Apply the desired topcoat of latex paint and allow to dry. 5. Install the wiring duct/raceway and covers. For small quantities, use the DCT duct cutting tool on page C1.34. For larger quantities use a miter cutting saw blade for clean burr-free cuts. Recommended blade: Carbide 80T or 100T; .90" thickness, .125 kerf. Cleaning solvents and cutting fluids that contain any of the following chemical agents should not come in contact with type NNC or type NE wiring duct. These chemicals are known to cause stress cracking in the halogen-free PPO material. • Hydrocarbons • Phenols • Ketones • Amines • Ethers • Organic, inorganic and oxidizing acids • Petrol Note: Panduit assumes no liability for the accuracy or completeness of this list. Part Number System for Panduct ® Wiring Duct G = Wide Slot Flush Design F = Narrow Slot Flush Design FL = Flexible Duct FS = Solid Wall Flush Design H = Wide Slot Hinged Design HN = Narrow Slot Hinged Design HS = Solid Wall Hinged Design D = Round Hole Flush Design NNC = Halogen-Free Design NE = Halogen-Free Wide Slot Design MC = Metric Narrow Slot Design LG = Light Gray WH = White BL = Black IB = Intrinsic Blue IG = International Gray -A = Adhesive Backed = Without Adhesive (leave blank) NM = No Mounting Holes In. or mm Ft. or m G .5 X .5 LG 6 -A Type Nominal Width Nominal Height Color Length In. or mm