PANDUIT: Electrical Full Line

For technical assistance in the U.S., call 866-405-6654 (outside the U.S., see inside back cover for directory) ELECTRICAL SOLUTIONS C1.7 B2. Cable Accessories C1. Wiring Duct C3. Abrasion Protection C4. Cable Management D1. Terminals D2. Power Connectors E1. Labeling Systems E2. Labels E3. Pre-Printed & Write-On Markers F. Index B3. Stainless Steel Ties C2. Surface Raceway E5. Lockout/ Tagout & Safety Solutions B1. Cable Ties A. System Overview D3. Grounding Connectors E4. Permanent Identification Panduct ® PanelMax ™ Noise Shield • Metal noise barrier reduces EMI noise coupling between noise emitting and sensitive cabling within a control panel; provides up to 20dB reduction in noise which is equivalent to 6 inches of air spacing • Installs directly to metal panel surface or within 2, 3, or 4 inch height Panduit wiring duct (when shield is installed with supplied bonding clips) • Perforated and pre-scored sections speed installation by allowing sections of the shield to be snapped off at pre-scored locations to easily cut to length with minimal deburring required • Vertical wall slots allow wires to cross the barrier at 90° when necessary, providing greater design flexibility • Horizontal cable tie slots allow cable bundles to be held in place using cable ties so cabling is kept near barrier for greater reliability and optimal aesthetics • Zinc plated steel surface in contact areas with sub-panel and bonding clip ensures continuity and is corrosion resistant • Black powder coated vertical surface for smooth edges • Meets UL 508/508A requirements as a barrier between conductors Performance Characteristics Noise Coupling vs. Frequency Noise Frequency (MHz) Noise Coupling (dB) PanelMax ™ Noise Shield delivers approximately 20dB of noise reduction across common industrial noise frequencies at 30mm wire separation . 0 -10 -20 -30 -40 -50 0 2.0 4.0 6.0 8.0 10.0 No Shield PanelMax ™ Noise Shield Relative noise reduction in dB over frequency range of the PanelMax ™ Noise Shield is shown below. Part Number Part Description Std. Pkg. Qty. SD2EMI EMI Noise Shield kit for 2" height Panduit Wiring Duct; (2) three foot sections, bonding clips, and anti-oxidizing paste. 1 SD3EMI EMI Noise Shield kit for 3" height Panduit Wiring Duct; (2) three foot sections, bonding clips, and anti-oxidizing paste. 1 SD4EMI EMI Noise Shield kit for 4" height Panduit Wiring Duct; (2) three foot sections, bonding clips, and anti-oxidizing paste. 1